Hunan Zhuohui environmental protection cylinder adjustment problem solution

The belt deviation issue in belt presses is a frequent and challenging problem to address. Hunan Zhuohui Environmental Protection Equipment Co., Ltd. has effectively solved the belt deviation problem and is sharing their solution with everyone for reference, hoping it will be helpful to many peers in the industry. The solution provided by Hunan Zhuohui Environmental Protection Equipment Co., Ltd. for solving belt deviation is as follows:

1. When installing the deviation adjustment system, Hunan Zhuohui Environmental Protection Equipment Co., Ltd. follows the following procedure for the cylinder sensor valve extension and retraction:

• For the upper belt deviation adjustment system: When the belt contacts the upper sensor valve, it retracts; when it contacts the lower sensor valve, it extends.
• For the lower belt deviation adjustment system: When the belt contacts the upper sensor valve, it extends; when it contacts the lower sensor valve, it retracts.
• For the concentration belt deviation adjustment system: When the belt contacts the upper sensor valve, it extends; when it contacts the lower sensor valve, it retracts.

1. If the belt of Hunan Zhuohui Environmental Protection Equipment Co., Ltd.'s belt press deviates, please follow the following steps to check:
2. First, check if the sensor valve is broken. Use iron to contact the sensor valve. If the light does not turn on when contacted, it means the sensor valve is broken and needs to be replaced.
3. If the sensor valve is working properly, check if the iron rod of the sensor pump can detect the sensor valve. Use the iron rod to detect the sensor valve. If the light turns on promptly, it means the detection is successful; otherwise, it means the detection has not been achieved. In this case, please move the sensor valve towards the direction of the sensor pump's iron rod to ensure that the iron rod can sensitively detect the sensor valve.

III. If the iron rod of the sensor pump of Hunan Zhuohui Environmental Protection Equipment Co., Ltd.'s belt press can sensitively detect the sensor valve but the belt still deviates, please follow the steps below:

1. The deviation adjustment principle and method for the lower belt and the concentration section are the same. The method is as follows:

• Normally, when the cylinder retracts, the belt moves towards the cylinder side; when the cylinder extends, the belt moves towards the opposite side of the cylinder. If the belt does not move in this direction, please adjust the angle of the roller opposite the cylinder. If the belt does not move towards the cylinder side when the cylinder retracts, please move the roller opposite the cylinder towards the feed port. If the belt does not move towards the opposite side of the cylinder when the cylinder extends, please move the roller opposite the cylinder towards the discharge port.

2. For the upper belt, normally when the cylinder extends, the belt moves towards the cylinder side; when the cylinder retracts, the belt moves towards the opposite side of the cylinder. If the belt does not move in this direction, please adjust the angle of the roller opposite the cylinder. If the belt does not move towards the cylinder side when the cylinder extends, please move the roller opposite the cylinder towards the feed port; if the belt does not move towards the opposite side of the cylinder when the cylinder retracts, please move the roller opposite the cylinder towards the discharge port.

If there is a belt deviation issue with Hunan Zhuohui Environmental Protection Equipment Co., Ltd.'s belt press, please follow the above procedures for inspection and operation. We hope this will be helpful to our customers.